Vegetable based, melt and pour soap base containing donkey milk, used for manufacture of opaque soap bars. Donkey milk is a powerful moisturiser full of healing, nutritional and rejuvenating properties for the skin. Rich in fatty acids, it allows the reduced appearance of fine lines and wrinkles and helps to regenerate damaged skin.
All vegetable based
Excellent foaming and lather
Gentle feel on the skin
Full of rejuvenating nutrients for the skin
Moisturising properties from a very high glycerine content which provides a pleasant skin feel
Suitable for slicing or molding
Superior colour stability even when kept at a high temperature for extended periods
Neutral odour provides excellent fragrance lift
Sodium Laureth Sulfate
Sodium Lauryl Sulfate
For quantities of 250lbs and higher, we will contact you with a shipping quote prior to processing your order.
Instructions for handling, molding and processing the Melt and Pour Soap base:
There are two ways to melt the soap base:
A jacketed hot water bath ideally with thermostatic control (like the soup small heating kettles in restaurants.)
Note: For simplicity you can use a double boiler pan with hot water in between. Instructions for double boiler are similar to microwave.
Thinly slice or grate the soap base for ease of melting.
Place the soap in a Pyrex cup and place it in the microwave for 30 seconds (For half a pound)
Remove and stir slightly.
Continue to microwave for another 30 seconds.
Add soap colorant and stir until blended (soap colorant should be minimal).
Add soap fragrance to the desired level, and stir gently and thoroughly
Pour soap into soap molds. Let cool and harden before popping out of the moulds.
For fast set allows the soap to cool for 10 minutes, then cover in plastic wrap and place in refrigerator (not the Freezer) until set.
Wipe and clean the microwave.
Things to beware and ensure in processing the Melt and Pour Soap base:
Never allow the soap to boil. Boiling might denature the color and cause a yellowish hue.
Children require adult supervision, and should not handle alone the hot and melted soap.
Ideally the soap temp. Prior to pouring should be between 55-60 Celsius. In other words you can put your finger in the soap and it shouldn't burn.
Do not over stir when mixing colors and fragrances. But if this happens allow 10 minutes of settling for the release of air bubbles. Air bubbles if tapped in the mould will spoil the transparency
Always pour on a leveled surface.
When placing an insert or an object in the soap. Pour the first layer and let cool. Insert the object. And when pouring the second layer it has to be higher in temperature up to 70 degrees Celsius. Otherwise separation of the two layers might occur.
Avoid diluting the soap with water or any other chemical. The only exception to this is to add a maximum of 5% glycerin should you need a softer or more transparent soap.
Avoid contact of soap with eyes.
Note: This information contained herein is offered only as a guide to the handling of this specific material and had been prepared in good faith by technically knowledgeable personnel. It is not intended to be all-inclusive and the manner, conditions and handling may involve other and additional considerations. No warranty of any kind is given or implied and The Chemistry Store.com Inc. will not be liable for any damages, losses, injuries or consequential damages which may result from the use or reliance on any information contained herein. Be the first to leave a comment for this product.
Tell a friend about this product
Notify me when Donkey Milk Melt and Pour Soap Base is in stock.